Our twisted fabric cable is supplied as one continuous length, not cut into separate 1m pieces. For a specific length such as 3m, 5m or 10m, choose that length option on the product page. If you need a length that is not listed, message us before ordering and we will confirm how it will be supplied.

2-core cable carries live and neutral and is used for double-insulated (Class II) lights, such as most plastic or fabric lamp fittings. 3-core cable adds an earth wire and is needed for metal fittings that require earthing. If your old lamp has two wires and the new cable has three, check whether the lamp is Class II before wiring. See our 3 core twisted cable.

The cores are 0.75mm². Our 3-core twisted cable measures about 7mm across, and the 2-core cable is slightly slimmer, with the exact diameter listed on the product page. If you need to feed it through a lamp base or a hole, measure the opening first and compare it with the cable diameter.

No, unless the product page says otherwise. Fabric-braided lighting cable is designed for dry, indoor use, so it should not be used outdoors or in damp areas such as bathrooms. For outdoor lighting, use cable that is rated for outdoor use, and ask a qualified electrician if you are unsure.

The cable is intended for 230V UK mains lighting. As a guide, 0.75mm² flexible cable is typically rated up to 6A, which is roughly 1,380W at 230V, but always check the rating on the product page and stay within the limit of your fitting. We recommend having mains wiring installed by a qualified electrician.

Yes. A competent person can fit a standard UK plug to the cable, and a 3A fuse is normal for lighting. Use 2-core cable only for double-insulated (Class II) lamps; metal lamps that need an earth require 3-core cable. If you are not confident wiring a plug, ask a qualified electrician.

Wrap a short piece of tape tightly around the point where you will cut, then cut through the middle of the tape with sharp scissors or cutters. The tape holds the braid in place. Strip the outer insulation carefully, and finish the cut end with heat-shrink or tape so the braid does not fray further.

If there is a safe route for the flex with no potential for damage, then a 2-core flex can be used to supply the plastic-fitted lamp holder. However in this case an isolator must be used in the base of the lampholder to ensure there is plenty of isolation to the metal parts of the lamp base.

2 core cable is comprised of live and neutral conductors only, suitable for the appliance Class. It is important to check your Appliance Class with your qualified electrical contractor.

2 core cable does not include an earthing wire and can be used with any electrical object that has a non-conductive outside surface. Any light, lamp bulb holder, or fitting with a conductive or metal outside surface must be earthed to prevent serious damage.

2 Core cables are used in general purpose applications such as home appliances and power tools and also used in low voltage where there is no need for grounding.